Baileigh Industrial IP-1306, Operator'S Manual

Page: 19 / 48

16
16
Attaching Dust Port
•
Facing the rear of the machine, locate the
dust port on the cutterhead assembly by
turning 2 dust port knobs.
•
To minimize sawdust accumulation on
your workpiece, attach either a 2-1/2
” or a
4
” vacuum hose to the dust port.
Dust Collection
It is recommended that a dust collection
system be used with this planer. It should
have a minimum capacity of 500 CFM.
Connect a 4-inch diameter dust hose (not
provided) to the port and secure with a hose clamp. If using a 2-1/2-inch dust hose, use the 4-
inch to 2-1/2-inch adaptor.
Important: Dryer vent hose is not acceptable for the collection of wood dust and
chips.
Important: If a dust collection system is not used, do not install the dust hood. Use
of the dust hood without dust collection will hasten the gathering of chips and dust around the
cutterhead area.
Securing Planer to a Table or Workbench
During operation, if there is any tendency for the planer
to tip over, slide or walk, the planer MUST be secured to
a supporting surface such as a workbench or table.
•
Four holes are provided (2 are shown at A below) to
securely mount the planer.
•
The surface you are mounting the planer on should
be perfectly flat.