Baileigh Industrial DP-1500VS, Operator'S Manual

Page: 26 / 64

23
23
Setting the Depth Stop
This machine has some built-in control stops that activate when either the front
depth scale or side depth scale ring reaches zero. Their functions include stop
drilling, reverse tapping, or return the drill bit to the start height.
1. Start in manual down-feed mode.
2. Set the tool depth to zero position by lowering a drill bit or tapping
tool to the surface of the piece part.
3. Hold in position. Manually hold the down feed handles (E) to
keep the bit in position or change to automatic mode to hold the
position. (To change from manual mode to auto mode, turn
handle (AJ) counterclockwise (ccw) about 7 turns.)
4. Set the depth scale stop (S).
For manual operations use the front depth scale
1. Loosen the lock handle (S) and adjust the depth indicator.
2. Lock the handle (S) to set the depth scale stop.
3. Release the handle (AK).
For drilling in auto mode use the down-feed depth scale
1. Loosen the handle (AK) and adjust the depth scale ring.
2. Lock the handle (AK) to set the depth stop.
3. Release the handle (S).
(Front depth scale is calibrated in
both inches and millimeters.)
1” of spindle depth on the side
depth scale ring will show as 1”
(25.4mm) on the front depth scale.
S AK
S
AJ
E
1” of spindle
depth
Front
Side
0
6
5
4
2
1
6
5
4
3
2
1
0 0
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0