Baileigh Industrial DP-1400VS, Operator'S Manual

Page: 45 / 48

42
42
TROUBLESHOOTING
SYMPTOM DISPOSITION
Drill insert in working piece and spindle
shaft stop.
1. Push emergency button
2. Turn off the power
3. Use hand to turn the spindle shaft countermarch.
Let the tool withdraw from the working piece.
4. Suction the chip on the hole.
5. Turn on power again.
6. Adopt slowly feed make sure in normal condition
then recovery the normal feed.
Cutting fluid in abnormal condition and
not supplied in adequate quantity. 1. Check the pump is running or not
2. Check if the hose is leaking or not.
Spindle shaft can not running
completely.
1. Check the belt tension condition
2. If belt tension is too loose, adjust the belt shifter,
otherwise change the aging belt.
Motor do not work
1. Check the power and switch
2. Check the power cable is damaged or not if cable
is broken, change it directly.
Spindle shaft has noise
1. Check bearing
2. Check V – belt, if tightly degree over specific
tension will cause noise.
Drill oscillation
1. Check chuck condition
2. Make sure the drill is properly fixed in the chuck.
Pump stop suddenly or slow down
1. Impeller is clogged.
2. Overloading protection device of motor starts.
3. Motor failure.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.