34
34
Blade tracking adjustment
The head pivot shaft is supported by eccentric
bushings. If blade tracks off center resulting in
crooked cuts, adjust as follows.
1. Loosen two set screws (A) from rear of head pivot
with 4mm hex wrench.
2. If blade tracks to right side (viewed from front of
machine), rotate right socket screw (under the
electrical box) clockwise with 5mm hex wrench.
3. If blade tracks to left side, rotate left socket screw
counterclockwise.
4. Tighten set screws (A) and operate saw to verify
correctness of adjustment.
A
