Baileigh Industrial CS-225M-V2, Operator'S Manual, Page: 23 / 52

20
20
OPERATION
Miter Angle
1. Loosen the two cap screws (A) enough to allow the saw
head to pivot.
2. Rotate the saw blade head assembly to the correct miter
angle.
3. Use the angle indicator (B) to get the initial setting for the
cut angle and verify with a protractor.
4. Check that the blade clears all parts of the vise by pulling
down on the feed handle.
5. Tighten the two cap screws (A) to secure the head at the
chosen angle.
Vise Operation
1. The vise is a self-centering vise with both the front and
back jaws move away from or toward the clamping
center point.
2. Use the hand wheel (A) to open and close the vise jaw
(B) and secure the work material.
3. Counter clockwise (ccw) to open jaws
4. Clockwise (cw) to close jaws
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy materials, make sure they are properly supported.
CAUTION:
Check that the cutting blade clears all parts of the vise
assembly before cutting. The blade can strike parts of the assembly (especially
during miter cuts) if not properly adjusted.
A
A
B
A
B