Bagela BA 10000, Operating Instructions Manual

Page: 7 / 26

Bagela Bagela Bagela Bagela

 

asphalt recycler asphalt recycler asphalt recycler asphalt recycler
BA 7000F / BA 10000 BA 7000F / BA 10000 BA 7000F / BA 10000 BA 7000F / BA 10000
   
5
4.2 Start-up
-
For engine start-up see separate operation instruction.
-
To attain the voltage required for starting the oil burner, push the accelerator lever up
against its maximum stop.
-
Engage the tumbler;
upper position = forward mode
middle position = neutral
lower position
= reverse mode, lever must be held down
THE POSITION OF THE OPERATING LEVER CORRESPONDS TO THE TURNING
DIRECTION OF THE TUMBLER.
-
Before reversing the tumbler, make sure it is revolving at slow speed.
-
To avoid excessive shocks on the structure due to unbalance in the tumbler, never move
the lever abruptly and in a jerky manner. However, any shocks due to rough treatment will
be absorbed by the shock valves.
4.3 Charging
-
Fill asphalt lumps into the recycler until the hydraulic oil pressure gauge shows approx. 80
bar.
DO NOT OVERFILL THE RECYCLER TO AVOID EXCESSIVE SMOKE EMISSION.
4.4 Burner operation
Caution: Do not start the burner unless the tumbler is turning.
-
Set burner to 1st firing stage (switch position 2).
-
After about 2 minutes, when the flame has stabilised, set burner to 2nd firing stage (switch
position 3).
-
Set thermostat to the required temperature.
I. first burner stage max. 180°C: red pointer
II. second burner stage max. 150°C: green pointer