Operating Manual BaehrTec S2000
Page 36/52
English– V101 – Status 07/2015
The filling level contacts that protrude from the tank walls
(48)
, must be
cleaned every four weeks. Please do not use cotton wool or wool cloths to
clean them, but rather a cloth or the Baehr wipes (Art-No. 11000)
5.3
Cleaning and disinfecting the fine filter
The BaehrTec S2000 is equipped with two fine filters
(47)
. Please always ensure that you
only fill the tank with spray solution approved for the device
(Baehr spray solution for
Baehr spray technology devices, Art-No. 22333)
.
Should you detect any contamination in
the tank, empty it completely immediately and rinse it with clear tap water. Use a microfibre
cloth to clean the tank wall if they are dirty.
Should the spray function malfunction at some point despite observing all of the cleaning
measures described here, then check the fine filters to see whether they are clogged. To
clean the fine filter,
please only do this if the spray function does not work perfectly
,
and please proceed as follows.
1)
Switch the device off and disconnect it from the power supply.
2)
Empty the tank completely.
3)
Remove and dirt from the tank.
4)
Rinse the tank with clear tap water.
5)
Empty the tank completely and dry it (microfibre cloth).
6)
Carefully unscrew the fine filter using a flat-head screwdriver and make sure that you
never damage the filter mesh.
Fig. 15
Fig. 16
Fine
