■
Disconnect the con::cube from power supply and open the cover to the terminal compartment.
■
Connect the black wire of the pump to
GND
of the 12 V power supply of the con::cube (black terminals at
the cottom of the con::cube).
■
Connect the red wire of the pump to the input of the digital relay (e.g.
45 Relay 1 NO
).
■
Connect the 12 V power supply of the con::cube (red terminals at the bottom of the con::cube) with a cable
bridge to the other input (e.g.
46 Relay 1 C
) of the used digital relay.
■
Check if the pump is set to step 3 to ensure the correct power consumption (see section 9.8).
■
Reconnect the con::cube to the power supply and wait until moni::tool has started up.
!
The pump must not run dry.
micro::station / nano::station, 03-2023 Release
www.s-can.at
Copyright © s::can GmbH
25 / 36
Summary of Contents for scan micro station
Page 1: ...Manual micro station nano station March 2023 Release S 36 M...
Page 2: ......
Page 35: ......
