Work Order Validation
WO validation is used to define if a work order shall be validated by the system before processing it .
Host Validation (Host Operation Mode)
In this mode the work order number will be sent to the ERP (DMS) system . Only after validation from the system the meter will
unlock . Afterwards the dispense data will be sent to the ERP system .
WO Valid. HOST
YES / NO
1 . Use the
Scroll
key to move the cursor to either
YES
or
NO
.
2 . Press
ENTER
.
PC Validation (PC Operation Mode)
In this mode the work order number will be sent to the PC (FMS Software) . Only after validation from the PC will the order
number is accepted .
WO Valid. PC
YES / NO
1 . Use the
SCROLL
key to move the cursor to either
YES
or
NO
.
2 . Press
ENTER
.
WO Archive (Printout or Storing of the Work Order /Dispense Results)
WO archived
None Mem Print
1 . Use the
SCROLL
key to move the cursor to your selection .
2 . Press
ENTER
.
Mem
Data stored in an optional memory module .
After each dispense, the data will be printed out on the
external printer .
Each line displays one dispense .
Archive on PC (Archive of the Work Orders/Dispenses)
Archive on PC ?
YES / NO
1 . Use the
SCROLL
key to move the cursor to either
YES
or
NO
.
2 . Press
ENTER
.
All dispense results are stored on the PC (FMS Software) . If the PC is currently not available, the data will be tagged as “not
sent” in the memory of the master . The data will be sent as soon as the PC is connected again .
Master Keypad
Page 13
December 2014
FMS-UM-01200-EN-01