CAUTION
ANY OTHER WIRING METHOD MAY BE UNSAFE OR CAUSE IMPROPER OPERATION OF THE INSTRUMENT. IT IS
RECOMMENDED NOT TO RUN LINE POWER WITH OTHER SIGNAL WIRES WITHIN THE SAME WIRING TRAY OR CONDUIT.
OTEE:
N
The flow meter requires clean electrical line power . Do not operate the meter on circuits with noisy components (for
example, fluorescent lights, relays, compressors, variable frequency drives and like equipment) .
The flow meter can be operated from a 10…15V DC source, using the included auto-style power cord, as long as it is capable
of supplying at least 40 watts . Observe proper polarity . Note that extended operation on an automotive supply could
substantially reduce the automotive battery .
WARNING
THE INTERNAL BATTERY PACK SHOULD ONLY BE REPLACED BY AN AUTHORIZED BADGER METER SERVICE
REPRESENTATIVE. PLEASE CONTACT YOUR PRODUCT AND/OR SERVICE PROVIDER FOR INTERNAL BATTERY
REPLACEMENT SERVICE.
Important Safety & Usage Instructions
Read these safety instructions carefully .
• Read all cautions and warnings on the equipment .
• Place this equipment on a reliable surface when installing . Dropping it or letting it fall may cause damage .
• Make sure the correct voltage is connected to the equipment .
• For puggable equipment, the socket outlet should be near the equipment and should be easily accessible .
• If equipment has reached its end of life, please recycle properly .
• Disconnect this equipment from the AC outlet before cleaning it . Use a moist cloth . Do not use liquid or spray detergent
for cleaning .
• To fully disengage the power to the unit, disconnect the power from the AC outlet .
• Do not scratch or rub the screen with a hard or sharp object .
• Never use any of the solvents, such as thinner spray-type cleaner, wax, benzene, abrasive cleaner, acid or alkaline solvent,
on the display . Harsh chemicals may cause damage to the enclosure and the touch screen sensors .
• Remove dirt with a lightly moistened cloth . Then wipe the enclosure with a soft dry cloth .
• The fins on the enclosure are for air convection and protect the equipment from overheating .
• DO NOT COVER THE OPENINGS .
• Position the power cord so that cannot be stepped on . Do not place anything over the power cord .
• If the meter will not be used for a long time, disconnect it from the power source to avoid damage by transient
over-voltage .
• Never pour any liquid into openings . This may cause fire or an electrical shock .
• Never open the equipment . There are no user serviceable parts inside . For safety reasons, the equipment should be
opened only by qualified service personnel .
• If one of the following situations arises, get the equipment checked by service personnel:
• The power cord or plug is damaged .
• Liquid has penetrated into the equipment .
• The equipment does not work properly, or you cannot get it to work according to the user’s manual .
• The equipment has been dropped or damaged .
• The equipment has obvious signs of breakage .
Safety
Page 9
November 2016
HYB-UM-00090-EN-04
