Badger Meter Cox 4050, User Manual

Page: 19 / 32

CXX-UM-01850-EN-01
POOGOAMMING MODE
Use Programming mode to set up and program Auto-Manifold and other features of the flow computer
THE INSTRUCTIONS IN THIS MANUAL ARE WRITTEN FOR THE REMOTE CONTROL UNLESS OTHERWISE INDICATED.
Enter Programming Mode
1 Navigate to the code entry screen using one of two methods:
◊ Press
LEFT/OIGHT arrows
until Secondary displays on the screen, then press
ALTEO
, or
◊ Press SHIFT , then the 6/CODE key
2 When the screen displays CODE **** , enter the four-digit serial number using the number keys The serial number is on the
back of the computer, on the screen when the computer is first powered up, or on the screen in the Front Panel Test mode
3 If you enter the wrong code, press
CLEAO
to clear the entry Then try again
The Programming menu opens when the correct code is entered
Exit Programming Mode
Press
CLEAO
to exit programming mode when you are finished programming
If you press the
ALTEO
key by mistake while selecting the secondary menu, wait 20 seconds and the primary menu displays
Automatic Lockout
In some cases the flow computer itself inhibits the
ALTEO
key as it may be performing a sequence of events that cannot be
interrupted, like batching Wait until the flow computer is finished with the process
Programming Mode Options
Menu Option Description
Setup Auto Opens the menu to set up setpoints for automatic switching
Setup Comms Set up the Port settings
Edit Curve
1
, Edit Curve
2
or Edit Curve
3
K-Factor programming for channel 1, 2 or 3
Ch
1
, Ch
2
or Ch
3
Setup Channel setup for channel 1, 2 or 3
Clear Totals 1 , Clear Totals 2 or Clear Totals 3 Use to clear measurement totals for channel 1, 2 or 3
Sort Curve
1
, Sort Curve
2
or Sort Curve
3
Use the sort function on curve 1, 2 or 3
Analog Inputs Calibrate the PT100 card
Set Viscosity Program fluid viscosity
Set SG Program fluid specific gravity
Sort Vis/SG/Temp Use the sort function on viscosity, specific gravity or temperature
Relays Manually open or close relays
Clear to Exit Press CLEAO to return to the Primary Menu
Cards Fitted Displays installed cards
Programming Mode
Page 19 February 2018