IAM-100 and Controller Manual
6209-9000 Rev 2
19
NOTE:
Connection to main power supply must be via an
approved, readily accessible, switched spur and fused (3 Amp
fuse) or as per local wiring regulations which should be within
3 meters (10 feet) of the controller. It should be part of the
building installation and be marked as the disconnect for the
device.
•
The main power cable used should be compliant
with local regulations.
•
If replacement of the main fuse is required, use a
suitable replacement.
4.3. Remote Sensor Installation
If you do not wish to surface mount the IAM or need to match room
decor, Bacharach can supply a remote sensor and a decorative
faceplate (standard finish is a unit with brushed stainless steel). The
remote sensor is mounted in an electrical back box 44 mm [1.73 inches]
deep to which the faceplate is fitted.
IMPORTANT:
Cleaning the decorative faceplate should be
limited to light dusting. It should not be sprayed with
cleaning/polishing aerosols.
NOTE:
For remote sensor configurations, the sensor
element is mounted on a small remote sensor PCB that
connects to the IAM-100’s main PCB via a 4-wire cable.
Summary of Contents for IAM-100
Page 7: ...IAM 100 and Controller Manual 6209 9000 Rev 2 7 Figure 3 Sample Architecture Diagram ...
Page 14: ...IAM 100 and Controller Manual 14 6209 9000 Rev 2 Figure 6 Controller Housing ...
Page 34: ...IAM 100 and Controller Manual 34 6209 9000 Rev 2 ...
Page 35: ...IAM 100 and Controller Manual 6209 9000 Rev 2 35 ...
