H25-IR PRO Instruction Manual
Operation
P/N: 3015-5678 Rev 6
34
CHAPTER 5: OPERATION
IN THIS SECTION
•
Introduction ............................................................. 34
•
Turning on the H25-IR PRO ....................................... 36
•
Function Reference .................................................. 35
•
Search Mode Screen ................................................. 36
•
Measure Mode Screen.............................................. 42
•
Basic Setup Screen.................................................... 45
•
Advanced Setup Screen ............................................ 53
•
Diagnostics Screen .................................................... 74
•
Adjustment to a Known External Leak Source ........... 81
•
Custom Gas Type Configuration ................................ 83
•
Factory Gas Type Configuration ................................ 84
5.1. Introduction
This section describes the operation of the H25-IR PRO. The instructions in this section assume the following:
•
You read and understood the previous sections.
•
You assembled and connected your gas probe.
•
You connected the power cord to an appropriate power supply receptacle.
•
You wired optional external devices to the relays, current output, and/or RS-232 computer connector as desired.
For basic applications, your H25-IR PRO is ready to use after you turn it on. If your application takes advantage of one or
more of the optional features, you should review the settings to ensure that any customizations you desire are properly
configured. Note that some features require both hardware configuration (e.g., wiring from relay outputs to external
notification devices) and firmware configuration (e.g., setup of menu parameters).
Table 5-1 on page 35 shows common application options and where to look for configuration information.
WARNING:
Explosion Hazard. Do not operate this instrument in the presence of flammable liquids, vapors
or aerosols. Operation of this instrument in such an environment constitutes a safety hazard.
NOTE:
Button images are used extensively in this chapter. When the MODE, VOLUME, SETUP, and RANGE
buttons are used as “arrow” buttons (to explain navigation and value adjustment procedures), each button’s
corresponding arrow is shown
with
the button image to illustrate more clearly its function in that particular
context.
Summary of Contents for H25-IR PRO
