10
for you. Special care should be
taken when cutting hair in these
areas to prevent injury.
• Remove any jewels like earrings,
necklaces, etc.
• Use your Easy Cut clipper
on clean, dry and carefully
untangled hair for best cutting
results.
• If your hair is long, cut it first
using the scissors and comb.
• Make sure the unit is sufficiently
charged, or plugged into the
mains.
CUTTING AND MAINTAINING
SHORT HAIR CUTS
• Turn the Easy Cut clipper using
the ON/OFF switch located on
the top of the unit. The blades
will start to move and the green
LED will come on.
• Move the clipper slowly and
smoothly around the scalp
beginning at the top of your
head.
• The clipper can be used in any
direction to cut your hair, but use
gentle pressure. If you feel the
unit resisting, turn it off, empty*
any hair that may have collected
in the clipper and start clipping
your hair again.
*Hair will collect inside the blade
ring and you may need to empty
it before you finish cutting your
hair. In this case, switch the clipper
off and remove the hair by gently
tapping on the top of the clipper
and using the cleaning brush.
• If using on zones where there
are folds of skin, pull the skin
taut with your other hand before
continuing to cut.
• If you would like a grade 0 cut,
the clipper can be used without
a comb guide attached.
CLEANING AND MAINTAINING
THE EASY CUT CLIPPER
To ensure optimum performance
of your clipper, we recommend
cleaning the clipper after every
use.
• Remove the comb guide, rinse
under running water and dry it
thoroughly before storing.
• Never place the clipper under
running water.
• Using the cleaning brush,
thoroughly clean all hair from
the inside of the blade ring.
• Before each use, we recommend
adding a few drops of oil
(provided) in the 3 oil slots inside
the blade ring.
(fig. 7)
• Wipe the outside of the clipper
with a damp cloth and dry
thoroughly before storing it.
USING THE FINISHING TRIMMER
The finishing trimmer operates on
2 AA batteries.
Open the battery compartment
cover by pushing it down and
sliding it open. Insert 2 AA
batteries as indicated in the
battery compartment. Replace
the cover by pushing it upward
until it clicks into place.
NOTE: If the clipper remains
unused for a while or if the
batteries have run down, remove
them from the unit. These
Summary of Contents for EASYCUT E940XE
Page 1: ......
Page 2: ...1 2 2 3 4 5 6 8 9 ...
Page 3: ...Fig 1 Fig 2 Fig 3 Fig 4 Fig 5 Fig 6 Fig 8 Fig 9 Fig 7 ...
