Customer Service
- If you are missing parts or have any questions about this product,
please contact us at : 1-800-762-1751
PART LIST
A [1] HEADBOARD
B [2] SIDE RAILS
C [1] FOOTBOARD
D [1] SLAT ROLL
E [5] SUPPORT LEGS
HARDWARE LIST
18pcs
1pc
4pcs
4pcs
5
4pcs
4
3
2
1
12mm Wrench
5/16" x 12mm Nut
ASSEMBLY INSTRUCTION
Note: Bed can be assembled by one person rather easily, but if two people are available
it is easier and the operation will require less preparation. The instructions are
written assuming one person is assembling the bed.
WARNING: ADULT ASSEMBLY ONLY OWING TO THE PRESENCE OF SMALL
PARTS, SHARP POINTS AND EDGES
1pc
4pcs
4pcs
4pcs
9
8
7
6
4mm Allen key
1/4" Flat washer
TOOLS NEEDED
- Screwdriver
1. Place the Headboard (A) upright in the position you wish the bed to be in when fully assembled.
The Headboard bedfast hardware should be facing the inside, toward the mattress.
Secure the Threaded Rod (
1
) to the Headboard (A). Place towels or some other soft item (not
included) under each Side Rail (B). These will protect the floor while lifting the rails, allowing for
easier attachment to the headboard & foot rail. Raise the Side Rail (B) up and place the rod into
the Side Rail (B) at the bore holes' position, insert Curved Slotted Washer (2) and tighten Hex
Nuts (3) using Hex Wrench (4)
(as shown in diagram 1)
.
Repeat the procedure with the side rail end and Footboard (C).
