Pro-Stitcher Lite for the Baby Lock Gallant/Villa Frame
Installation Instructions | 15
Villa Frame Table Top Installation Instructions
Parts List
PART NUMBER
DESCRIPTION
QTY
QF01501-RAW
4-Foot Table Top Section
2
QF00043
Double-sided Foam 118 inches
1
Tools Needed:
• Scissors for cutting foam tape (not included)
Â
IMPORTANT
: Removing the frame poles
will make it easier to place the table-top
sections.
Â
IMPORTANT
: Before installing table-top
sections, confirm that guide rails and tracks
are in the correct position, by placing the
machine and carriage on the tracks and
rolling it from end to end, checking for
smooth movement and no binding.
1. Cut the double-sided foam tape to fit the
crossbar supports and apply the adhesive side of
the foam tape to all six cross-bar supports.
2. Remove the protective cover from the tape on
the three crossbar supports on the right side of
the frame.
3. Remove the clear backing from the smooth
bottom side of both table tops. The textured
side goes up.
4. Starting at the right vertical brace, butt the end
of one table-top section against the brace and
align it between the guide rails. Make sure the
table-top section is between the front and rear
guide rails and does not overlap the lip of either
guide rail. Do not press the section down into
the foam tape until both table-tops are in place.
5. Remove the protective cover from the foam
tape on the three remaining crossbar supports.
6. Butt one end of the second table-top section
end against the end of the installed table-top
section and align between the rails. When
correctly positioned, press the table-top
sections firmly onto the foam tape.
PART NUMBER: QF01501
vertical
brace
guide
rails
crossbar
supports
table-top section
table-top section
