T
H
R
E
A
D
I
N
G
14
Chain Looper
1. With the presser foot up and machine lock button in the locked position, see fig. A page 13.
2 Place the thread cone or spool on the "Chain Looper" spool pin. Slip the thread into the tele-
scopic antenna thread guide above the thread cone.
3. Insert the thread through the hole of the thread guide above the chain looper tension dial.
Bring the thread under the chain looper tension dial, then up and over the left thread
guide,making sure the thread is in the tension disk. (See fig.A).
4. Take the thread down to the chain looper threading port.
5. Pull 18 inches (40cm) of thread and insert 1 inch (10cm) of thread into the chain looper thread-
ing port. Use tweezers if necessary, to insert the thread end. (See fig. B).
6. Depress the looper threading lever. (See fig. B). If the thread does not go through the chain
looper eye with one push, depress the threading lever again until it does.
7. Open side cover to the left for easy access to the chain looper thread in tray. See fig. C.
8. Trim excess thread to 4 inches (2.5cm) from the eye of chain looper and leave it hang.
9. Close side cover.
10. Move the lock button release lever to the right.
A
B
Side
Cover
Chain Looper
Thread Tray
C
