Baby Lock ECS8, Instruction Manual

Page: 154 / 271

152
Basic Design Center Operations
■
Importing into Layout & Editing
The embroidery pattern created in Design Center
can be imported into Layout & Editing, where it can
be edited and combined with other embroidery
patterns.
Click , or click Stage , then To Layout &
Editing .
→
Layout & Editing starts up.
Specify settings for Magnification and
Orientation .
The maximum magnification ratio that can be
specified is the ratio that enlarges the design
to the size of the Design Page. The minimum
magnification ratio is 25%.
Click Import .
→
The embroidery pattern created in Design
Center is imported into Layout & Editing.
a
Note:
Sewing attributes for region cannot be
applied to open regions (regions not fully
enclosed in an outline), as shown in the
illustration below.
If attributes cannot be applied to a region,
return to the Figure Handle Stage and make
sure that region is closed. Edit any broken
lines with the Point Edit tool.
c
“Drawing a broken line” on
page 161.
b
Memo:
From the Sewing Attribute Setting dialog
box, detailed settings for attributes, such as
the width of satin stitches and the run pitch,
can be specified.
c
“Specifying sewing attributes” on
page 165.
a
Note:
If the sewing attributes of an outline or region
are not set, the embroidery pattern cannot
be imported.
b
Memo:
An embroidery pattern (.pem data) created in
Design Center cannot be written to an original
card. Import the embroidery pattern into
Layout & Editing, and then write the data to a
card in order to transfer the pattern to an
embroidery machine.
1
2
3