B-TEK Scales T403S, User Instructions

Page: 61 / 74

BTEK T403S Indicator User Instructions 61
7.4 Checkweighing application supervisor menu
7.4.1 Check
Super

Setpoint

Tare

Check
1. With the Checkweighing application active, access the Supervisor menu using
password 1793. Refer to
Accessing the menus on page 30 for instructions.
From SuPEr , press SELECT …
SEtPnt is displayed.
2. Press UNITS twice …
chEcK is displayed. This stands for checkweigher. Use this to set the
items relating to checkweighing:
l
Set conditions for using the outputs. ( outPutS )
l
Set under divisions for acceptable target weight ( undrdiv )
l
Set over divisions for acceptable target weight ( oVErdiV )
l
Reset the target values to zero.( rESEt )
Outputs - Latch & Unlatch
Check  Outputs  Latch & Unlatch
3. Press SELECT …
outPutS is displayed. There are two choices for outputs, LAtch and
unLAtch . If you choose LAtch , this means that the weight has to
stabilize before the annunciator and output for the appropriate condition
(Under, Accept or Over) is activated. If you choose
unLAtch , the
annunciator and output will change instantly as the weight changes
checkweigh condition.
In latch mode, once activated the annunciator and output will remain
unchanged until the item is removed and the gross weight returns to
inside the gross zero band.
4. From outPutS , press SELECT …
LAtch is displayed.
5. Press UNITS to toggle between the choices and when your choice is
displayed, press ZERO to accept …
outPutS is displayed.
Under divisions
Check  Outputs  Under divisions
6. Press UNITS …
undrdiv is displayed. Use this to set the number of divisions (0-100)
below the target weight that is still within the accept window.
If the checkweigh mode is currently using the LO and HI limit values, viewing or
entering the Under or Over division settings will change these Limit values
accordingly.