B-TEK Scales T403S, User Instructions

Page: 27 / 74

BTEK T403S Indicator User Instructions 27
3.5 Batching application
4. To stop the batching process, press STOP or F1 . ( F1 toggles the process on
and off.)
3.5.6 Independent setpoints
Independent Setpoint works like the general weighing mode setpoints with the addition
of start/stop controls. You can also do negative weight/discharge using this mode.
1. Press SETUP or press and hold SELECT to access the setpoint editor.
2. Set Out1, Out 2 and Out 3 values.
3. To start or restart the setpoints, press START or F1 .
4. To stop the process, press STOP or F1 . ( F1 toggles the process on and off.)
3.5.7 Fill/Discharge
Fill/Discharge mode is typically used for applications that use negative filling to
dispense a smaller amount of product from a large vessel, tank or hopper type scale.
The vessel (tank or hopper) is filled to a set gross weight and then multiple operations
of filling via negative amount of weight into bags or containers can be completed before
the vessel (tank or hopper) requires a recharge or refill.
Fill Out 1 is assigned as the gross fill amount for the vessel (tank or
hopper) and
START or F1 key starts the fill. The fill is based only
on gross weight. If you have Out 1 set to 2000 and the scale
already has 500 lb remaining, the Output 1 will cutoff (and
annunciator
SP1 turns off) when the additional 1500 is added for
a total gross of 2000 lb.
Discharge Out 2 is assigned as the discharge fill amount (negative weight)
with the
TARE key used to initiate the discharge cycle. The scale
will tare prior to activating Output 2 ( SP2 annunciator will light). An
operator can perform multiple discharge operations. When the
vessel gross weight is low, perform a refill.
1. Press SETUP or press and hold SELECT to access the setpoint editor.
2. Set Out1 to the gross fill weight in the vessel or container. Set Out 2 to the
weight of the product to be discharged into smaller bags or containers.
3. To start or restart the large vessel fill process, press START or F1 .
4. To stop the large vessel filling process, press STOP or F1 .
5. Press TARE to start the bag filling process.
6. To stop bag filling process, press STOP or TARE .