Cleaning System ud-800 Page 16
9.
Working with the Machine
9.1.
Operational Procedure
Working with the manual cleaning area of the machine (see also Figure 4-1 & Figure 4-3)
Open the main door. The exhaust suction system starts working automatically.
Activate the pump for the brush with the toggle-switch labelled "Brush". The recircu-
lating cleaning fluid from the 60 litre container flows through the brush.
The clean rinse nozzle can be activated by the toggle-switch "Clean rinse". Fresh clean-
ing fluid flows from the 30 litre container.
The output can be adjusted with a flow adjuster (See colour coding on this page or
section 9.2).
Brush
Clean rinse
Colour coding of the hoses for the manual cleaning area:
Green: Brush
Black: Clean rinse nozzle
With the blow-off gun you can dry objects or spray guns. You can disconnect the blow-off gun and
plug in the cleaned spray gun to blow it out into the blow-off opening.
When the manual cleaning area is no longer required, close the main door. The exhaust suction stops
automatically.
Do not allow the doors to slam shut! All doors must be handled
carefully and with caution by the user!
Working with the automatic cleaning area of the machine (see also Figure 4-1 & Figure 4-3)
Open the main door. The exhaust suction system starts working automatically. Open the door of the
automatic cleaning chamber and place the gun as follows (Figure 9-1):
1.
Remove the lid of the cup and place it into the lid support fork. Ensure that the paint-soiled
inner surface faces downwards towards the interior of the cleaner.
2.
Paint spray gun without strainer: Place the gun upside down on the paint channel nozzle with-
out pulling the trigger. The cup stays screwed.
Paint spray gun with strainer: Unscrew the cup and place it upside down on the cup holder.
Remove the strainer from the spray gun and place it on one of the tines of the lid support fork.
Then place the spray gun upside down on the paint channel nozzle without pulling the trigger.
3.
Now the gun is inverted. Pull back the trigger and dip it with the trigger clamp. Keep trigger
clamp always in cleaning chamber.
This ensures that the paint channel is opened for cleaning and remaining
paint can drain from cup connection socket.
