IR-B02 Page 9
equipment and facility engineering
Waterborne primer
---
8-10
Waterborne basecoat
---
5
5. Replacement of emitter lamp tube
Interrupt the power supply, before replacing the infrared tube!
1.
Remove the side panel.
2.
Release the radiating panel.
3.
Loosen the two leads in the lamp and remove them.
4.
Remove the protective net in front of the emitter.
5.
Take out the defect tube and fix the new tube with same model number and wire the tube
properly.
6.
Install the protective net, radiating panel and the side panel.
Use a piece of soft cloth or cotton to clean the reflector panel and the tube with alcohol. Cleaning
must be conducted after the machine is disconnected with the power and cooled down. You are not
allowed to start the lamp tube until the alcohol becomes volatile, otherwise it may lead to explosion!
Disconnect
the wires of the emitter
1
2
3
4
5
6
