B.Pro SAW 1, Translation Of The Original Operating Instructions, Page: 14 / 56

14
B.PRO food serving trolley / cutlery soaking trolley OPERATING INSTRUCTIONS
Risk of explosion!
If containers with explosive materials are stored in the unit and the unit is put into operation, this
may cause an explosion and subsequent injury and damage to property.
–
Do not store any explosive materials, such as aerosols with flammable propellant, in the unit.
Heavy unit that may tip over!
Improper unit transport can lead to serious injury or damage.
–
Transport the unit in an upright position only.
Transport in a goods or delivery vehicle!
–
Only transport the unit in a goods vehicle with a sufficiently sized loading ramp or a delivery
vehicle.
–
Make sure that the loading ramp does NOT exceed an angle of inclination of 10°.
–
Secure the unit to prevent it from moving around (safety harness).
)
The unit is not properly secured for transport if only the castor brakes have been applied.
–
Secure the unit against vertical movement during transport.
–
Use padded locking bars.
–
Make sure that the unit is secure and cannot slide during transport or fall from the loading
area.
Flammable protective film!
Protective film that has not been removed may ignite after unit commissioning.
–
Remove all protective film when unpacking the unit.
Electric shock due to electrical charge, danger of short-circuit!
When the unit is brought from a cold storage room to a kitchen, moisture from the air in the room
condenses on the surface of the unit.
When the unit is connected to the power, there is a danger of the resulting moisture film causing
a short-circuit or an electric shock.
–
Only operate the unit once it has reached room temperature.
–
Only operate the unit on an even, firm surface.
–
NEVER operate the unit next to equipment which emits large amounts of steam, such as a
dishwasher.
Wrong mains voltage! Missing circuit breaker!
Improper handling of the mains plug and mains connection can lead to serious injury or damage.
–
Make sure that the mains voltage and frequency on the rating plate correspond with those for
the mains socket outlet.
–
Only connect the unit to a socket outlet that is protected with a fault-current protective device
(residual-current circuit breaker). Make sure that every phase is also fused with max. 16 A.
Transport
Commissioning