B.Pro B.PROTHERM BPT 820 EB, Translation Of The Original Operating Instructions, Page: 12 / 48

B.PROTHERM stainelss steel, heated
– 8 –
Power plug
Unplug the power plug before cleaning the unit. Water penetrating into the
convection heating module can cause a short-circuit. If this happens, there is
a risk of electric shock.
Cleaning water
A danger of slipping exists if cleaning water runs out during or after cleaning.
Completely wipe up water which runs out onto the floor.
Thoroughly dry the unit after cleaning. Remove cleaning water from the floor
of the unit interior.
Hot convection heating module, hot unit parts and objects
The convection heating module, unit interior and the objects located within
become hot while the unit is in operation (danger of burns!). Allow the unit to
cool off before it is cleaned.
Maintenance Castor brake
Regularly check the effectiveness of the castor brakes.
If the effectiveness of the brakes is not sufficient, have the defective castor
replaced immediately by one of the following:

In-house, B.PRO-trained professionals

External, B.PRO-trained customer service

B.PRO Service
Periodical electrical safety inspection
At least once every six months, have a periodical electrical safety inspection
carried out by a professional electrician in accordance with the
DIN VDE 0701-0702 series of standards.
Connection cable and power plug
At least once every six months, check the connection cable and power plug
for mechanical damage and signs of excessive ageing in accordance with
BGV A 3 or the corresponding national regulations.
Repairs Authorised persons
The unit may only be repaired by the following service points:

In-house, B.PRO-trained professionals

External, B.PRO-trained customer service

B.PRO Service
The warranty will be invalidated if the unit is repaired by anyone else or without
being commissioned.
Replacement of components of unit electrical system
Components of the unit electrical system (e.g. switch, power cable, etc.) may
only be replaced by qualified personnel (e.g. an electrician), and only parts
with the same specifications may be used.
Standards and guidelines Observe the applicable standards, guidelines and safety regulations.
The operator is responsible for compliance with the applicable standards,
guidelines and safety regulations.
Product marking The unit is provided with a rating plate. The warranty is voided if the rating
plate is removed.