B+K precision 5490C Series, User Manual

Page: 48 / 57

40
function
RL1 Remote control / local function
DC1 Device clear function
DT1 Device trigger function
C0 No controller function
E1 Open collector drive
8.4.2 Setting the GPIB Address
The instrument's GPIB is addressed in a single address mode with no secondary address; the default
GPIB address is 8. Users can set their own GPIB address (0~30), and the address value can be
automatically saved in non-volatile memory. In a GPIB bus system, it is not allowed to assign the same
address as other devices or controllers (computers).
8.4.3 General Bus Commands
General bus commands (like DCL) are the same meaning regardless of the machine. General
commands and auxiliary instructions:
Command Description Control instructions for the 5493C multimeter
REM REMOTE 8 Bring the instrument into remote control mode
IFC ABORT 8 Reset the instrument interface to the idle state
LLO LOCAL
LOCKOUT Block local messages so that all keys on the panel
are inoperable
GTL LOCAL 8 The instrument returns to local control and the
buttons on the panel are active.
DCL CLEAR Clear all instrument input and output buffers
SDC CLEAR 8 Clear the input and output buffer of 5493C
GET TRIGGER 8 Trigger the instrument once, the measurement
result will be sent to the output buffer after
measurement.
SPE,SPD SPOLL 8 Serial point command
For a detailed description of the General Bus Command (SCPI), see Chapter 8: SCPI Command
Reference.
8.4.4 Setting through the interface
Press Menu
→
Utility
→
I/O Config
→
GPIB to Enter GPIB Settings Screen.