LED function display during the self-testing cycle (approx. 60 s)
Function
Zone left LED1 (red)
Zone right LED2 (red)
Zone UKS LED3 (red)
Programming-LED (red)
Self-testing cycle reprogrammed
after power from the mains has
been switched on
All 3 LEDs flash simultaneously
Self-testing cycle reprogrammed
after power from the mains has
been switched on
LEDS flash rapidly
Self-testing cycle double-locked
after power from the mains has
been switched on
All 3 LEDs will each flash at one-second intervals for 80 ms
LED function display during operation
Motion detection
LED will flash when a motion is
detected
LED will flash when a motion is
detected
LED will flash when a motion is
detected
Party mode active
Red and green LEDs will flash alternately for 0.5s
Registration
LED will flash during the registra
-
tion process
Initialization
The LED will light up continuous-
ly after successful initialization
(key pressed for longer than 3 s)
until it is released
IR command
The 3 LEDs will flash once
11. LED function display
2. 1CH/2CH channel settings
Option 1 (1CH)
1CH
Simultaneous Switching
Mains Switching
Wireless - Lux and Motion
Target brightness value
Day mode:
Light sensor inactive, switches at every brightness /
Night mode:
Very low activation value of around 10 lux
Automatic reading in of the current light value as the new target light value
Continued running time
Permanently deactivate the LEDs on the device
12-hour party mode:
Light on for 12 hours
Activating testing mode when closed
Deactivation:
Press reset
Resetting when closed
End testing mode
Accept standard settings
Switch light on/off
1CH mode
Alarm function
This key opens the detector to allow the following functions to be programmed.
Attention:
The detector will be automatically closed
•
each time the power is switched back on
•
or after 3 min.
Condition is changed, „closed“.
The white LED will flash every 0.5 seconds in the first 5 seconds.
Sabotage prevention may be activated during this time.
Permanent sabotage prevention
First open the device, then close the device, LED will light up for 5 seconds
Sabotage prevention may be activated during this time. Either carry out a reset
(see Point 4) or proceed as follows to exit this mode:
1. Interrupt the power
2. Apply power for 31 to 59 seconds
3. Interrupt the power again
4. Apply power
5. Open the detector
max
50
Lux
1500
Lux
ON
OFF
t < 5 s
10
Lux
����
���
min
1
��
���
1CH
Alarm
10. remote control IR-SMARTHOME
Unlocking the device
or
or
or
to
optional
or
Locking the device
Deactivate LEDs
Permanent sabotage
prevention
10
Lux
����
���
��
���
Reset when open:
Deletion of all values
set with the remote
control, potentiometer
settings will apply.
max
50
Lux
1500
Lux
ON
OFF
t < 5 s
max
50
Lux
1500
Lux
ON
OFF
optional
30
min
15
min
1000
Lux
500
Lux
min
5
Alarm
min
1
min
2
1
TEST
+
–
S
Lux
300
Lux
50
Lux
10
B.E.G.
LUXOMAT
®
10
min
S
LED
IR-SMARTHOME
B.E.G.
LUXOMAT
®
1CH
2 CH
RESET
2C H
1
Bild-BA-RC-plus-next-230-ZW_050913_GB.indd 4
05.09.2013 10:01:17
