background image

troubleshooting:

• 

Leaks between cap and bottom of filter housing:

Turn off water supply and turn on drinking water 
faucet to release pressure in system. Remove bot-
tom of housing. Clean O-ring and O-ring groove 
(located directly beneath threads of housing). Lu-
bricate O-ring with silicone grease and replace se-
curely into groove. Screw bottom of housing onto 
cap and hand-tighten. DO NOT OVER  TIGHTEN. 
Turn on water supply and check for leaks.

• 

Leaks on system inlet /outlet connections:

Turn off water supply and turn on drinking water 
faucet to release pressure in system. Remove 
tubing from fitting and make sure end of tubing is 
cut squarely and free of burrs. Reinsert tubing into 
fitting, making sure to push tubing to a hard stop. 
Hand tight compression nut first, then tighten 1 to 
1 1/2 turns for new compression nut. Tighten only 
1/2 to 1 turn with wrench for previously tightened 
compression nut.

• 

Leaks on faucet / tubing connection:

Turn off water supply, then turn on drinking water 
faucet to release pressure in system. Loosen and 
remove compression nut fitting on faucet stem. 
Make sure tubing is inserted firmly into end of 
faucet stem, then retighten compression nut with 
fingers until secure. Turn on saddle valve, then 
turn off faucet to check for leaks.
NOTE: If leaks persist, or if there are other leaks 
on system, turn off water supply. 

Low Water flow:

1. 

Check flow at faucet. The # 9333 system 

should fill a gallon jug in approximately 2 minutes. 
Flow rates will vary with individual household 
water pressure.

2. 

Check filter cartridge installation. Make certain 

all filter cartridges are properly oriented in filter 
housings.
 
B. David specific / Replacement Filter Cartridges  
1. Stage # 1: RS-90 

  

2.  Stage # 2: RC-93
3. Stage # 3: RP-100
Complete System
# 9333 Nano filtration system

9333

 

Nanotechnology Under Counter Water Purification System                          

  P/N 161131 Rev C 

 

8

Hel neu st 57

B. David LIMITED WARRANTY

B. David warrants to the original owner (under normal use): all products 
and parts to be free from defects in material and workmanship for a 
period of one (1) year. Not withstanding the foregoing, (a) the warranty 
period for sumps shall be a period of five (5) years. Any replacement 
products furnished will be free from defects in material and/or work-
manship for the remainder of the original warranty period or 30 days, 
whichever is longer. This warranty does not cover: (1) cartridges and 
accessories (2) defects not reported within the above time period, (3) 
items manufactured by other companies, (4) problems arising from fail-
ure to comply with B. David instructions, (5) problems and/or damage 
arising from acts of nature. abuse. misuse, negligence or accident by 
any party other than B. David, (6) problems and/or damage resulting 
in whole or in part from alteration. Modification, repair or attempted 
alteration. modification or repair by any party other than B. David, (7) 
noncompliance with applicable codes/ordinances.

If a defect in workmanship and/or material in a product or part covered 
by the warranty should a rise, B. David, at its sole discretion, will repair 
or replace the defective product or part B. David may consider in good 
faith, the customer’s preference).

All claimed defective product must: (1) be authorized for return by B. 
David with an RGA number (2) include proof of the purchase date of 
the product or part (3) returned to B. David prior to the expiration of the 
warranty date at the customer’s expense. shipment pre-paid,
(4) be accompanied by a letter detailing the Model Number, Serial Num-
ber (if any), and a brief description of the problem.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW. B 
DAVID DISCLAIMS ALL OTHER WARRANTIES, WHETHER EXPRESS 
OR IMPLIED, INCLUDING, BUT NOT LIMITED TO. THE IMPLIED WAR-
RANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR 
PURPOSE, WITH REGARD TO THE PRODUCTS. PARTS AND ANY 
ACCOMPANYING WRIT  TEN MATERIALS.

To the maximum extent permitted by applicable law, B. David shall not 
be liable for any damages whatsoever (including, but not limited to, loss 
of time, inconvenience, expenses, labor or material charges incurred in 
connection with the removal or replacement of the products or parts, 
special. Incidental, consequential, or indirect damages for personal 
injury, loss of business profits, business interruption, loss of business 
information, or any other pecuniary loss) arising out of the use of or 
inability to use the defective products or parts even if B. David has been 
advised of the possibility of such damages.
B. David’s maximum liability under any provision of this limited Warranty 
shall be limited to the amount actually paid for the products or parts.

NOTE: Because some states do not allow the exclusion or limitation of 
incidental or consequential damages, the above limitations or exclu-
sions may not apply.
THIS WARRANTY GRANTS SPECIFIC LEGAL RIGHTS, ANO OTHER 
RIGHTS MAY APPLY. SUCH RIGHTS VARY FROM STATE TO STATE.

 
 
 

Summary of Contents for RS-90











Reviews: