63
SE400 SERIES
X-Ring Elite Groups
The X-Ring Elite Groups page allows you to select the function and role for each device and
the connected ports.
To access this page, click
L2 Switching
>
X-Ring Elite
>
X-Ring Elite Groups
.
Figure 74: L2 Switching > X-Ring Elite > X-Ring Elite Groups
The ensuing table for
Information
settings is informational only: Ring ID, Role, Port 1, Port 2
and
Delete
(click to delete the desired Ring ID).
The Loopback Detection function is used to detect looped links. By sending detection frames
and then checking to see if the frames returned to any port on the device, the function is used
to detect loops.
Global Settings
The Global Settings page allows you to configure the state (enabled or disabled) of the func-
tion, select the interval at which frames are transmitted and the delay before recovery.
To access this page, click
L2 Switching
>
Loopback Detection
>
Global Settings
.
Figure 75: L2 Switching > Loopback Detection > Global Settings
The following table describes the items in the previous figure.
The ensuing table for
Loopback Detection Global Information
settings are informational
only: State, Interval and Recover Time.
Loopback Detection
Table 57: L2 Switching > Loopback Detection > Global Settings
Item
Description
State
Select
Enabled
or
Disabled
to set up the loopback mode.
Interval
Enter the variable in seconds (1 to 32767) to set the interval at which frames
are transmitted.
Recover Time
Enter the variable in seconds (60 to 1000000) to define the delay before
recovery.
Apply
Click
Apply
to save the values and update the screen.
