B+B SMARTWORK SmartMotion, Configuration Manual

Page: 45 / 144

4. CONFIGURATION
4.4.1 Connection to Mobile Network
If you mark the Create connection to mobile network checkbox, then the router automati-
cally attempts to establish a connection after booting up. You can specify the following param-
eters for each SIM card separately.
Item Description
APN Network identifier (Access Point Name).
Username User name for logging into the GSM network
Password Password for logging into the GSM network
Authentication Authentication protocol in the GSM network:
•
PAP or CHAP
– The router selects the authentication method.
•
PAP – The router uses the PAP authentication method.
•
CHAP – The router uses the CHAP authentication method.
IP Mode Specifies the version of IP protocol:
• IPv4 – IPv4 protocol is used only (default).
•
IPv6 – IPv6 protocol is used only.
•
IPv4/IPv6
– IPv4 and IPv6 independent dual stack is enabled.
IP Address In IPv4 and IPv4/IPv6 mode only. Specifies the IPv4 address of the SIM
card. You manually enter the IP address, only when mobile network
carrier assigned the IP address.
Phone Number Specifies the telephone number the router dials for a GPRS or CSD
connection. The router uses a default telephone number *99***1 #.
Operator Specifies the carrier code. You can specify the parameter as the PLNM
preferred carrier code.
Network type Specifies the type of protocol used in the mobile network.
•
Automatic selection
– The router automatically selects the trans-
mission method according to the availability of transmission tech-
nology.
•
It’s also possible to select a specific method of data transmission:
LTE , UMTS/HSPA , GPRS/EDGE .
PIN Specifies the PIN used to unlock the SIM card. Use a PIN parameter
only if the network requires a SIM card router. The SIM card is blocked
after several failed attempts to enter the PIN.
Continued on next page
35