User Manual
Page 13
of 44
2.
When the DSL Port is connected to the VDSL/ ADSL Server and dialed
successfully, the DSL LED will keep solid on all the time.
3.
When the Ethernet Port is connected to the computer, the Ethernet LED
will blink all the time.
4.
When the pots port is connected to the phone cable and registered
successfully, the phone LED will keep solid on.
Setup the Computer
The default IP address of the Router is
192.168.254.254
, the default Subnet
Mask is
255.255.255.0
. Both of these parameters can be changed as you
want. In this guide, we will use the default values for description.
Connect the local PC to the LAN port on the Router. There are two ways to
configure the IP address for your PC.
Configure the IP address manually
1.
Right-click on
My Network Places
–
Properties
, then right-click
Local
Area Connection
–
Properties
; double click on
TCP/IP Protocol
.
2.
Configure the network parameters manually. Set the IP address to
192.168.1.xxx
(“xxx” range from 2 to 254). The Subnet Mask is
255.255.255.0
and Gateway is
192.168.254.254
(Router’s default IP
address).
Obtain an IP address automatically
Set up the TCP/IP Protocol to Obtain an IP address automatically mode on
your PC.
Now, you can run the Ping command in the command prompt to verify the
network connection between your PC and the Router. Open a
command
prompt
, and type in
ping
192.168.254.254
, then press
Enter
.
