Azbil ALTJ 9000 Series, User Manual, Page: 40 / 68

9-2
Chapter 9 Maintenance and Inspection
9-2 Disassembly and Assembly
The following gives the procedure if each part must be disassembled or assembled to check the seal, replace parts, or
clean the device.
„
Disassembling the Probe
Do not disassemble the probe if possible, in order to maintain airtightness. Before disas-
sembling the probe, be sure to turn off the power. Additionally, before disassembling a
probe that is pulled out of the water, be sure to wipe off all moisture.
Fig. 9-1. Structure of the probe
Hollow cable
Gland
Shell
Cover (upper portion)
Connector
Housing
Printed circuit board
Seal cap (balloon)
Meterbody
Cover (lower portion)