CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
AX-LR902
I N S TA L L AT I O N I N S T R U C T I O N S
AxxessInterfaces.com
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
REV. 9/25/18 INSTAX-LR902
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell
caps, etc.) • Zip ties
TABLE OF CONTENTS
Connections to be made ....................................2-3
Installing the AX-LR902 interface .........................3
Programming the ASWC-1 interface ................. 3-4
Screen operation ................................................4-6
Land Rover
Range Rover Evoque
Data Interface with SWC & Factory Display Retention
2014*
• Provides accessory power
• Designed for non-amplified models
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains audio controls on the steering wheel
• Retains parking sensor chimes
• Retains balance and fade
• Retains factory features: date, time
• Retains most of the vehicle settings that was displayed on the
factory radio *
• Micro “B” USB updatable
*
Attention!
The aftermarket radios backup camera input will be used to display the vehicle settings. If the radio doesn’t have a backup camera
Input, then there will be no visualization of the vehicle settings. An externally mounted screen could be substituted in this situation.
• AX-LR902 interface
• ASWC-1 interface
• AX-LR902 harness
• ASWC-1 harness
• Female 3.5mm connector with stripped leads
• Chime speaker
* For models with rear parking sensors
