ABMAX A
CCESS
P
OINT
I
NSTALLATION
AND
M
AINTENANCE
G
UIDE
V
ERSION
1.1
21
6.3 Install the Interconnect Cables (Transceiver End)
1)
Remove the grommet and clamping plate from the outdoor transceiver by removing the two
screws.
Figure 6-1: Grommet Location - Underside of Access Point
Note:
The Grommet is made of a special conductive material used to complete the ground
between the Access Point and wallbox.
2)
Insert the cable end through the grommet clamping plate (Figure 6-1:)
3)
Insert the cable end through the grommet. The tapered end of the grommet should be
opposite the cable end.
4)
Strip 1/2 inch of insulation off the cable end. Trim the wire ends flat as shown in Figure 6-2.
Figure 6-2 Outdoor Transceiver End of the Interconnect Cable with Cable Preparation
