www.axtelworld.com
10
5.2 Making a call
Desk phone:
Desk phone – to make a call, press the MFB
on the headset
or the Desk Phone button
on the base and dial the appropriate
number on the desk phone keypad.
Available only with a proper EHS cable.
Mobile phone and computer
Making calls from a mobile phone or computer is done from con
-
nected devices.
5.3 Call managing
Answering another call and putting the current call on hold.
To put the current call on hold and answer an incoming call, press
the MFB
for 2 seconds or press the button on the base corre
-
sponding to the source of the call.
Answering another call on a different channel and ending the current
call.
To end the current call and answer an incoming call, shortly press
the MFB on the headset.
Switching between active channels
a) From the
headset
– by pressing the MFB
for 2 seconds
b) From the
base
– by selecting the desired channel and pressing
the corresponding button.
When switching between active channels, the current connection
will be put on hold. Return to the call on hold by repeating the
above operation.
5.4 Adjusting the volume for each channel separately
Microphone sensitivity and speaker volume can be adjusted as ne
-
eded. Adjusting the volume in the headset is done by pressing the
+/-
buttons located on the upper part of the headset.
(Figure 6)
.
The lowest and the highest settings are indicated by a sound si
-
gnal.
Microphone sensitivity can be adjusted using the buttons on the
back of the base. Sensitivity is set individually for each channel
separately (desk phone, computer, mobile phone).
This is an extremely convenient solution that allows you to per
-
fectly adjust the device to your individual preferences.
5.5 Muting the microphone (MUTE)
Microphone muting (MUTE) is activated
a) from the headset: By pressing both
+/-
volume control buttons
on the headset simultaneously.
b) From the base by pressing the Mute
Microphone mute is indicated by the illumination of the micro
-
phone mute LED indicator on the base and by an acoustic signal
(played in a loop every 10 seconds).
