F A U L T
C A U S E
R E M E D Y
⁄ Insufficient water
⁄ Aerator calcified, dirty
⁄ Clean aerator, replace as necessary
⁄ filter insert shower dirty
⁄ Clean filter insert between shower and
hose
⁄ Instantaneous heater didn’t work
⁄ filter insert shower dirty
⁄ Clean filter insert between shower and
hose
⁄ check valve hasn't moved back
⁄ Exchange check valves
0 2
EN
S A F E T Y N O T E S
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal pressures.
I N S T A L L A T I O N I N S T R U C T I O N S
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective
countries must be observed.
T E C H N I C A L D A T A
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 70°C
Recommended hot water temp.:
65°C
Thermal disinfection:
max. 70°C / 4 min
⁄ Safety against backflow
⁄ The product is exclusively designed for drinking water!
S Y M B O L D E S C R I P T I O N
Do not use silicone containing acetic acid!
M A I N T E N A N C E (see page 07)
The check valves must be checked regularly
according to EN 806-5 in accordance with
national or regional regulations (at least once a
year).
D I M E N S I O N S (see page 06)
F L O W D I A G R A M (see page 07)
C L E A N I N G (see page 10)
S P A R E P A R T S (see page 08)
O P E R A T I O N (see page 09)
Hot surface!
A S S E M B L Y (see page 09)
