Axon Body 3 Camera
User Manual
Axon Enterprise, Inc.
Page 31 of 44
If the battery depletes significantly during use, the camera display will show LOW BATTERY
and the camera emits 4 quick tones and 4 short vibrations. This message indicates that
approximately 20 percent of the battery capacity remains. The message is repeated after
every 5 percent decrease in battery capacity.
Always recharge a depleted battery as soon as reasonably possible.
Charging an Axon Body 3 Camera while Powered Off
Note:
Your Axon Body 3 camera must have Operating System (OS) v1.7 or later to charge
the camera while powered off.
Prior to Axon Body 3 camera Operating System (OS) 1.7, an
Axon Body 3 camera that was powered off would automatically power on when connected
to a USB-C cable to charge.
The Axon Body 3 camera can be charged by using a USB-C cable while the camera is off. This
allows users to charge the Axon Body 3 camera battery when an Axon Body 3 Dock is not
available. However,
Axon recommends that you regularly place you Axon Body 3 camera in
an Axon Body 3 Dock to ensure that the camera has the correct time synchronization and
latest firmware updates.
If needed, you can request a USB A to USB C cable directly from Axon. Contact your Axon
Representative or Axon Support for assistance.
1.
While your Axon Body 3 camera is powered off, connect the camera to a USB-C cable.
2.
Connect the cable to a power adapter or, for a USB-C to USB-A cable, to a USB port.
The camera enters low-power mode and the current charge level is shown on the
camera display.
The Operation LED color also provides a visual indication of the charge level. The LED is
red when the charge level is less than or equal to 33%, yellow when the charge level is
34% to 97%, and green when the charge level is 98% or higher.
While charging with the camera powered off, you can:
•
Power on the camera by pressing the Power button until you feel a short vibration.
The camera starts and enters Ready (buffering) mode.
•
Shut down the camera by disconnecting the USB-C cable.
