12
For the rear camera, the installer should find a proper location, based on the particular
installation.
•
For the rear camera, Installer can use Axon View XL to find the location that best
views the cage area.
•
For proper adhesion, ensure the rear camera is mounted on a flat surface.
Axon Signal Vehicle Unit
For information on installing the Axon Signal Vehicle unit, refer to the
Axon Signal
Vehicle Installation Manual
.
Step 2:
Wiring the Axon Fleet Mount/Camera Unit
The Axon Fleet camera is a mounted camera that draws power from the Axon Fleet
power unit, and therefore they must be wired together.
1
Unscrew the outside shell of the Axon Fleet camera mount.
2
Use a small screwdriver to unscrew and raise the screws in the green camera
unit connector.
3
Locate the 18-foot (5.5 m) wiring harness.
Do not strip more than 0.25
′′
(6.35 mm) of insulation from the wires.
4
Confirm the exposed part of the wires are not nicked.
5
Place the stripped wire ends into the connections in the correct slots.
•
White – A
•
Violet – C
•
Green – D
•
Gray – E
6
Tighten the appropriate screws to clamp down on the exposed wire ends.
7
Inspect the connector to confirm that:
•
The wires are attached securely to the Fleet connector.
•
No frayed wire strands are outside the cage clamps.
