Axminster Trade AT305PS, Original Instructions Manual

Page: 21 / 142

Instruction manual for 12” panel saw
18
3-7. FITTING RIP FENCE
Remove the washer and nut from the round bar first and then
1. Insert the screw rods H (Fig. 3-7.1a) of the round bar into the position A (Fig.
3-7.1) of working table and extension table then put the washers and nut at the
back side of the table, then fasten them in (there are 4 points for fixing the round
bar in this position).
2. Mount the fence scale (ruler) set to the edge of the working table and extension
table by fastening the fence scale (ruler) set with washer and lock washer
3. Slide rip fence support C (Fig. 3-7.1)into round bar D (Fig. 3-7.1)
Note: Move handle E (Fig. 3-7.1) up to release rip fence, down to lock the rip
fence.
4. Mounting fence plate F (Fig. 3-7.1) to clamping assembly in upward position and
tighten handle G .
Notice: Before operation, the 0 mark on the rip fence scale must be aligned with
the right side of the blade to ensure the processing accurate.
All fitting operations in this section require approx. 2 people
F
G
C
D
E
A
B
Figure 3-7.1
H