Axminster Trade AT260PT, Original Instructions Manual

Page: 20 / 60

Setting up the Machine
20
Digital Thickness Display
Hex key
Straight edge
Tip of blade
Straight edge
Vernier
The ‘Digital Display’ will give an accurate visual indication of
the amount you are adjusting the thicknessing table in 0.10mm
increments.
The digital display should be pre-set at the fatory but if
required can be set as follows.
1. Place a straight edge across the thicknessing table, raise the
table until the tip of the cutter-block blade at it’s lowest point
is touching the top of the straight edge, see fig A-B.
Fig A-B
Fig C
Fig D-E
2. Using a vernier, measure the height of the straight edge
and write down the reading, see fig C. Loosen the grub screw
holding the collar mechanisum, turn the collar on the digital
display unit and dial in the measurement you wrote down, see
fig D-E. Tighten the grub screw, clamping the collar to the drive
shaft.
3. Remove the stright edge from the thicknessing table.