3
Assembly
Stand Assembly
Referring to Figure 1:
1. Remove all contents from the shipping
container.
2. Clean all rust protected surfaces with a mild
solvent. Do not use paint or lacquer thinner,
gasoline, or mineral spirits; these will damage
painted surfaces.
3. Attach
the
four
rubber pads
(A) to the bottoms
of the
side panels
(C) with four each
hex nuts
(B). The hardware can be found
in the bag with the rubber pads.
4. Attach
the
side panels
(C) to the
front panel
(D)
with four 5/16” x 5/8”
hex cap screws
, eight
5/16”
flat washers
, four 5/16”
lock washers
, and
four
5/16”
hex nuts
(E). Hand tighten the
hardware at this point.
Note:
Assemble the stand upside down to
make sure that the tops of the panels are flush.
5. Mount
the
shelf
(F) to the inside of the stand
with two
M5x10
pan head screws
, two M5
flat
washers
and two M5
lock washers
(G).
6. Finish the stand assembly by attaching the
rear
panel
(H) to
side panels
(C) with four
5/16” x 5/8”
hex cap screws
, eight 5/16”
flat
washers
, four 5/16”
lock washers
, and four
5/16”
hex nuts
(J).
7. Make sure stand is sitting evenly on a level
surface before tightening hardware.
Installing Table and Motor Unit to Stand
The Table and Motor Unit is
heavy! Use great care and adequate resources
when lifting the unit up onto the stand! Failure
to comply may cause serious injury and/or
damage to the sander and/or property!
Referring to Figure 2:
1. With the aid of another person, carefully lift the
table and motor unit
(A) out of the shipping
box, and up onto the
stand
(B).
2. Line up threaded holes in the
base
(C) with the
holes in the
stand
(D).
3. Open the
cabinet door
(E) and through the
opening attach main unit to stand with two
5/16” x 1-1/4”
hex cap screws
(F), two 5/16”
lock washers
(G) and two 5/16”
flat
washers
(H). Tighten with a 12mm wrench.
Figure 2
