Appendix B: The Config File
AXIS StorPoint HD
81
User’s Manual
Appendix B
The Config File
Parameter name
Value
Description
[Server]
HardwareAddress
= 00:40:8c:11:00:86
The StorPoint HD hardware address. Default setting is the serial
number, or you can set a Locally Administrated Address. The
value shown is an example only.
Date
= 97-01-01
yy-mm-dd, enter the date followed by ! to set manually
Time
= 12:00:00
hh:mm:ss, enter the time followed by ! to set manually
FactoryDefaults
= no
Set this parameter to yes to reset to factory default settings.
Restart
= no
Set this parameter to yes to restart the StorPoint HD.
[SCSI]
SCSITermination
= on
Internal SCSI termination setting. This is always on, therefore the
StorPoint HD must always be located at the end of the SCSI bus.
[IP]
InternetAddress
= 192.36.253.80
The StorPoint HD Internet address. The value shown is an
example only.
DefaultRouter
= 0.0.0.0
All traffic directed outside the local network (according to the
NetMask) is sent to the default router. Any re-routing via other
routers is done automatically. The default 0.0.0.0 indicates that
no default router is set.
NetMask
= 0.0.0.0
Used to determine when the traffic should be sent via a router.
For example the normal class C mask is 255.255.255.0. The
default 0.0.0.0 indicates that automatic router sensing is used.
BOOTPEnable
= yes
Enable or disable bootp IP address setup.
RARPEnable
= yes
Enable or disable rarp IP address setup.
DHCPEnable
= no
Enable or disable dhcp IP address setup.
[SMB]
EnableNetBEUI
= yes
Enable or disable SMB over NetBIOS/NetBEUI.
EnableNBT
= yes
Enable or disable SMB over NetBIOS/TCP/IP.
EnableWINS
= yes
Enable or disable WINS over NetBIOS/TCP/IP.
PrimaryWINSserver
=
Primary WINS server address.
SecondaryWINSserver
=
Secondary WINS server address, if required.
NBTscopeID
=
Always Enabled. Default: Empty String.
Domain/GroupName
= WORKGROUP
The name of the StorPoint HD workgroup.
ServerName
= AXIS110086
The server name in the Microsoft Network environment, where
110086
are the last 6 digits of the serial number. The value
shown is an example only.
NetBEUIFrameType = auto
If auto is selected 802.2 or DIX will automatically be selected by
scanning the network. If required, the frame type can also be set
to either 802_2 or DIX.
ShowPseudoShares
= yes
Enable or disable whether the cd, config, root, and volumes
folders are visible.
