AXIS Q6042-S PTZ Dome Network Camera
Multi-Connector Cable
Multi-Connector Cable
Note
The supplied multi-connector cable is required in order to maintain the camera’s NEMA/IP rating.
The multi-connector cable is connected to the camera’s multi-connector, see
Hardware Overview on page 7
.
The wires are connected to the supplied media converter switch, see
Media Converter Switch on page 9
.
The cable provides the following signals:
•
DC power to camera
•
Network (Ethernet 10/100Base-T)
•
Input/Output (I/O)
1
2
3
4
5
6
7
8
9
10
12
11
1
8
2
7
9
3
6
4
5
Multi-connector cable overview
1
Power wire (red)
2
Digital I/O wire (blue)
3
Ethernet wire (green/white)
4
Ethernet wire (green)
5
Ethernet wire (orange/white)
6
Ethernet wire (orange)
7
Digital I/O wire (yellow)
8
Ground wire (black)
9
Power wire (red)
10 Ethernet wire foil shield (2x)
11
Outer foil shield
12 Braided shield coil
Function
Pin – wire
Notes
Specifications
Digital input – Connect to pin 8 to activate, or
leave floating (unconnected) to deactivate.
0 to max 30 V DC
Configurable (Input
or Output)
2 – blue
7 – yellow
Digital output – Connected to pin 1 when
activated, floating (unconnected) when
deactivated. If used with an inductive load, e.g. a
relay, a diode must be connected in parallel with
the load, for protection against voltage transients.
0 to max 30 V DC, open
drain, 100 mA