Axis Q1615-E Mk II, Installation Manual, Page: 14 / 150

AXIS Q1615-E Mk II Network Camera
Status LED behavior and buzzer signal for leveling assistant
For information on the function button used for leveling the camera, see page 15 .
Press and hold the function button (2) for more than two seconds to level the camera.
• When the camera is level, both LEDs are steady green, and the beep is continuous.
• When the camera is not level, the LEDs flash a combination of red, green and orange, and
the beep occurs at slow intervals.
Both LEDs briefly flash green to indicate that the leveling is getting better.
SD card slot
NO NO NOTICE TICE TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects, or excessive force when
inserting or removing the SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product
is running. Unmount the SD card from the product’s webpage before removal.
This product supports microSD/microSDHC/microSDXC cards.
For SD card recommendations, see axis.com .
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO NO
NOTICE
TICE
TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer’s instructions. For information
about regulatory requirements, see
Electromagnetic compatibility (EMC) on page 4 .
I/O connector
Use the I/O connector with external devices in combination with, for example, motion detection,
event triggering, and alarm notifications. In addition to the 0 V DC reference point and power (DC
output), the I/O connector provides the interface to:
Digital input - For connecting devices that can toggle between an open and closed circuit, for
example PIR sensors, door/window contacts, and glass break detectors.
14