Axis Q1614, Installation Manual

Page: 18 / 124

AXIS Q1614 Network Camera
SD Card Slot
Supports microSD cards with up to 64 GB of storage. For best recording performance, use a
microSDHC or microSDXC card with speed class 10.
Install the Hardware
NOTICE NOTICE NOTICE
Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required. Any
network cables that are routed outdoors or in demanding electrical environments shall be
shielded (STP) and intended for their specific use.
1. Optionally connect external input/output devices, such as alarm devices. See Connectors,
on page 15 for information on the terminal connector pins.
2. Optionally connect an active speaker and/or external microphone.
3. Connect the camera to the network using a shielded network cable.
4. Connect power, using one of the methods listed below:
- PoE (Power over Ethernet). PoE is automatically detected when the network
cable is connected.
- Connect an external power adapter to the power connector block. See
Connectors and Buttons, on page 12 .
5. Check that the indicator LEDs indicate the correct conditions. See the table on page
11 for more details. Note that the Status LED can be configured to be unlit during
normal operation.
6. Optionally insert a microSD card (not included) into the SD card slot.
NOTICE NOTICE
NOTICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to
Setup > System Options > Storage > SD Card and click Unmount .
Access the Product
Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on
www.axis.com/techsup/
Adjust Focus
To adjust the zoom and focus follow these instructions:
18