Axis P3364-VE, Installation Manual, Page: 20 / 168

AXIS P33–VE Network Camera Series
1. Remove the side lid that is attached to the unit casing by removing the screw.
2. Loosen the two screws on the cable shield and detach the bottom part.
3. Attach the bottom part of the cable shield to the unit casing with the screw.
1
Top part of cable shield (optional accessory)
2
Bottom part of cable shield (optional accessory)
3
Unit casing
Route the Cables along the Wall
Note
To avoid moisture-related problems it is recommended that the cables are routed to the
camera from below with the cable holes facing downwards.
1. Drill four holes in the wall using the drill template.
2. Attach the mounting bracket to the wall using four screws appropriate for the wall
material.
3. Remove the camera unit from the unit casing by pushing the springs aside.
4. Remove the bottom gaskets in the unit casing. If there is only one cable, remove only
one gasket.
5. Place the unit casing on the mounting bracket and attach it by tightening the four screws.
6. Pull the network cable and, if required, the I/O and audio cables up through the bottom
holes in the unit casing.
7. Drag the gaskets along the cables and plug them into the holes. The gaskets should fit
snugly in the holes with no folds or bends.
8. Re-attach the top part of the cable shield by tightening the two screws.
20