Axis P1425-E, User Manual, Page: 62 / 65

AXIS P1425-E Network Camera
Technical specifications
Technical specifications
You can find the latest version of the technical specifications at www.axis.com
LED Indicators
Status LED Indication
Unlit Connection and normal operation.
Green Shows steady green for 10 seconds for normal operation after startup completed.
Amber Steady during startup. Flashes during firmware upgrade or reset to factory default.
Amber/Red Flashes amber/red if network connection is unavailable or lost.
Red Firmware upgrade failure.
SD card slot
For SD card recommendations, see www.axis.com
Buttons
Control Button
For location of the control button, see Hardware overview on page 7 .
The control button is used for:
• Resetting the product to factory default settings. See page 57 .
• Connecting to an AXIS Video Hosting System service. See page 49 . To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 49 . To connect, press and hold the button for about 3 seconds.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO NO
NOTICE
TICE
TICE
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network
cable (STP) may be appropriate or required. All cables connecting the product to the network and that are routed outdoors
or in demanding electrical environments shall be intended for their specific use. Make sure that the network devices
are installed in accordance with the manufacturer’s instructions. For information about regulatory requirements, see
Electromagnetic Compatibility (EMC) on page 2 .
I/O connector
Use with external devices in combination with, for example, tampering alarms, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
62