Axis P1367, Installation Manual, Page: 15 / 134

AXIS P1367 Network Camera
4. Move the pullers to set zoom and focus and check the quality of the image in the image
window.
5. Re-tighten the zoom and focus pullers.
6. Click
Autofocus .
How to adjust focus with the Focus Assistant
Note
• The view in front of the camera should not be changed during focus adjustment. If the
camera is moved, or if a finger or other object is placed in front of the lens, restart the
procedure.
• If movements in front of the camera cannot be avoided, the Focus Assistant should not
be used.
• If the control button is not released within two seconds, AXIS Internet Dynamic DNS
Service is enabled instead of the Focus Assistant. For more information about AXIS
Internet Dynamic DNS Service, see
www.axis.com .
If the Status LED flashes either red or amber before you are able to adjust the lens, exit the Focus
Assistant and restart the procedure. See
Status LED behavior for focus assistant on page 18 .
1. Mount or place the camera so that it cannot be moved.
2. Loosen the zoom puller by turning it anti-clockwise. Move the puller to set the zoom
level. Retighten the zoom puller.
3. Set the camera to its extreme distant-focus position by loosening the focus puller and
turning the focus ring fully clockwise.
4. Press and quickly release the control button. When the status indicator flashes, the
Focus Assistant is enabled.
5. Gently turn the focus ring anti-clockwise until it stops.
6. Turn the focus ring slowly clockwise until the status indicator flashes green.
7. To exit the Focus Assistant, press the control button. If you cannot access the control
button, the Focus Assistant switches off automatically after 15 minutes.
8. Re-tighten the focus puller.
9. Go to the
Image tab in the product's webpage.
10. Click Autofocus and follow the instructions from the wizard.
15
EN