AXIS M7116 Video Encoder
Specifications
For SD card recommendations, see
.
microSD, microSDHC, and microSDXC Logos are trademarks of SD-3C LLC. microSD, microSDHC, microSDXC are
trademarks or registered trademarks of SD-3C, LLC in the United States, other countries or both.
Buttons
Control button
The control button is used for:
•
Resetting the product to factory default settings. See
Reset to factory default settings on page 16
Connectors
Bus connector
The bus connectors are the physical interfaces to the video encoder chassis that provide power, network, RS485, and I/O terminal
connections.
BNC connector
Each video input is terminated using a coax/BNC connector.
Connect a 75 Ohm coaxial video cable; the recommended maximum length is 250 m (800 ft).
Note
75 Ohm video termination can be enabled/disabled for the video input through the product's webpage at . Video termination
is enabled on factory default. If the product is connected in parallel with other equipment, for optimum video quality, we
recommended to enable video termination only for the last device in the video signal chain.
Network connector
RJ45 Ethernet connector.
Power connector
2-pin terminal block for DC power input. Use a Safety Extra Low Voltage (SELV) compliant limited power source (LPS) with either
a rated output power limited to
≤
100 W or a rated output current limited to
≤
5 A.
RS485/RS422 connector
Two 2-pin terminal blocks for RS485/RS422 serial interface. The serial port can be configured to support:
•
Two-wire RS485 half duplex
21
