Axis AXIS P1357-E, User Manual, Page: 65 / 68

AXIS P1357-E Network Camera
Technical specifications
For SD card recommendations, see www.axis.com
Buttons
Control Button
For location of the control button, see Hardware overview on page 7 .
The control button is used for:
• Enabling the Focus Assistant. Press and very quickly release the Control button.
• Resetting the product to factory default settings. See page 59 .
• Connecting to an AXIS Video Hosting System service. See page 50 . To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 50 . To connect, press and hold the button for about 3 seconds.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO NO NOTICE TICE TICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shall
be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer’s
instructions. For information about regulatory requirements, see the Installation Guide available at
www.axis.com
About I/O connectors
Use the I/O connector with external devices in combination with, for example, tampering alarms, motion detection, event triggering,
and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
Digital output - For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface or in the product’s webpage.
Digital input - For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
Note
The I/O connector is connected to the housing (fan/heater) on delivery. In case of a fan or heater error, an input signal will be
triggered in the camera. Set up an action rule in the camera to configure which action the signal shall trigger.
4–pin terminal block
Note
The I/O connector is connected to the housing (fan/heater) on delivery. In the case of a fan or heater error, an input signal
will be triggered in the camera. Set up an action rule in the camera to configure which action the signal shall trigger. For
information about events and action rules, see
About events on page 38 .
65