AXIS A8207-VE Mk II Network Video Door Station
Additional settings
Note
Use NAT traversal when the device is connected to the network from behind a NAT router or a firewall. For more information
see .
10. Click
Save
.
Set up SIP through a server (PBX)
VoIP (Voice over IP) is a group of technologies that enables voice and multimedia communication over IP networks. For more
information, see
Voice over IP (VoIP) on page 15
.
In this device, VoIP is enabled through the SIP protocol. For more information about SIP, see
Session Initiation Protocol (SIP) on page 15
There are two types of setups for SIP. A PBX server is one of them. Use a PBX server when the communication should be between an
infinite number of user agents within and outside the IP network. Additional features could be added to the setup depending on the
PBX provider. For more information, see
Private Branch Exchange (PBX) on page 16
1. Request the following information from your PBX provider:
-
User ID
-
Domain
-
Password
-
Authentication ID
-
Caller ID
-
Registrar
-
RTP start port
2. Go to
System > SIP > SIP accounts
and click
+ Account
.
3. Enter a
Name
for the account.
4. Select
Registered
.
5. Select a transport mode.
6. Add the account information from the PBX provider.
7. Click
Save
.
8. Set up the SIP settings in the same way as for peer-to-peer, see
Set up direct SIP (P2P) on page 9
. Use the RTP start
port from the PBX provider.
Create a contact
This example explains how to create a new contact in the contact list. Before you start, enable SIP in
System
>
SIP
.
To create a new contact:
1. Go to
Contact list
.
2. Click
+ Add contact
.
3. Enter the first and last name of the contact.
4. Enter the contact’s SIP address.
10
